80mm Down Pipe Bend 95° The 80mm Down Pipe Bend 95° is a replacement pipework fitting designed for compatible dairy, agricultural, wash, water and general transfer systems. With an 80mm specification and 95° bend angle, it provides a practical change of direction where pipework needs to turn neatly within a suitable installation. Down pipe bends are useful where a pipe run needs to be routed around equipment, walls, tanks, drains or plant room layouts while maintaining a secure connection. If the original bend becomes cracked, worn, loose, damaged or difficult to seal, the system may suffer from leaks, poor alignment or unreliable flow. Replacing it with the 80mm Down Pipe Bend 95° helps restore a dependable pipework route and supports consistent system performance. This bend is useful for dairy farms, engineers and service teams carrying out repairs, refurbishment or planned maintenance on compatible water, wash, plant room or transfer pipework. The 95° angle can help where a slightly wider turn than a standard 90° bend is needed to suit the existing pipe run or fitting position. Keeping common pipe bends available can make on-site repairs quicker and help reduce avoidable downtim
